Table of Contents
Advertisement
INSTALLATION
7.1 Open the microscope box. Remove (column) from
the box. Engage this column onto the shaft by aligning 3
guide holes on column and shaft, shown as B in Fig 13.
7.1a Tighten three Allen screws from the sides, shown as
C in Fig 14.
7.2 Make sure that during assembly of the column, ring
D) is fixed in place, as shown in Fig. 15
7.3 Retrieve the swivel arm and suspension arm
assembly from the packing box and follow
instruction as below (refer Fig. 3)
Ensure loosening of swivel arm lock knob( A).
Install the swivel arm assembly on the upright
holding shaft (1) figure 3.
Lock the swivel arm with threaded plug (2) from
the top.
Put protective cap (3) in place and loosen
suspension arm locking B knobs so that it can be
rotated.
11
6165000-795
A
PRIMA GN
Prima GN
B
Fig 13
C
Fig 14
D
Fig 15
3
2
1
B
Fig. 3
Issue 1.4
Printed on March, 2016
Advertisement
Table of Contents
