Table of Contents
Advertisement
7A. INSTALLATION
7.1 Open the Microscope Box. Remove pillar (Column) from
the box. Engage this column onto the shaft matching the
guide holes on column has shaft, shown as B in fig.-13.
7.1 a Tighten three allen screws from the sides, as shown as C
in Fig.-14.
7.2 Make sure that during assembly of the column ring D is
fixed in place, as shown in Fig.-15.
7.3 Remove the arm assembly from the box and follow
the instructions below (see Fig.-3).
A. Ensure loosening of swivel arm lock knob (A).
B. Place the arm assembly on the column shaft (1) shown in
Fig.-3.
C. Screw in the threaded plug from the top (2).
D. Put the protective cap (3) in place, and loosen the suspen-
sion arm locking knob (B) so that it can be rotated.
6165000-795
Prima GN
B
Fig. 13
C
Fig. 14
D
Fig. 15
3
2
A
1
B
Fig. 3
Issue 1.9
Printed on May,2023
PRIMA GN
9
Advertisement
Table of Contents
