Display Elements - AUMA DREHMO i-matic Manual

6. LOCAL CONTROLS
From software version V01.06.0080 (IM; IMC all software versions), a temporary language
modification can be performed from the basic screen (which is automatically reset after next
system start) by holding down the ESC push button/key for approx. 5 seconds, followed by
acknowledgement of the language change (always to English) by pressing the ENTER push
button/key. For permanent language selection, please use the configuration as indicated
above.

6.5 Display elements

After switching on, the main screen is displayed and all local indication lights (refer to
number 6 in figure 6.1) and activated for approx. 3 seconds. During operation, the main
data is shown in the display as indicated in figure 6.4.
(a) Display elements for display version 1
(b) Display elements for display version 2 or display
version 1 as IMC-version
Actuator position is displayed as bar graph and in figures according to the configured position
unit (1 in figure 6.4). As standard, end position CLOSED corresponds to a position of 0 %
(bar completely empty) and end position OPEN to 100 % (bar completely filled).
i-matic
1. Actuator position actual value
2. Torque indication (here: torque in di-
3. Currently assigned push button/key
4. Information symbol (bell or warning tri-
5. Fieldbus state (here: two channels are
6. Display of mode of operation
7. Set tripping torques
Figure 6.4: Display elements
rection CLOSE of approx. 55%)
function
angle)
available, exchanging data)
27