Servicing and maintenance
8.3.1 Additional steps if the grinding wheel is stuck
1
Image 19 – Loosen stuck grinding wheel
1. Push the lever or similar [19-1] between chassis and grinding wheel and
press it carefully against the inside of the grinding wheel.
2. Rotate the grinding wheel by 90° and repeat the process until the grinding
wheel has detached from the centring flange.
8.4 Installing the grinding wheels
When installing new grinding wheels, also install the enclosed plastic discs.
When turning around the previous grinding wheels, replace the enclosed
plastic discs.
1. Carry out the steps for removal (see 8.3 Removing the grinding wheels) in
reverse order.
There is a difference between right and left flange cover. Direc-
tion arrow from the flange cover must match the one on the
machine.
2. In order to ensure good and safe knife guidance, place knife guides as
close as possible to the grinding wheels without touching them. (see 6.4.1
Adjusting the knife guides (grinding angle))
3. Insert the mains plug.
4. Switch on the machine and test run it for one minute. In case of unusual
behaviour, switch off the machine immediately and check all individual
parts for proper condition and assembly.
[19-1] Lever
NOTE
Operating instructions, SM-110/-111
8
39