Switching On The Machine - Dick SM-110 Operating Instructions Manual

Putting the machine into operation
In order to protect the motor from damage due to overload, the machine
is equipped with an overload switch [9-3]. This triggers in the event of an
overload. The switch button activates and interrupts the power supply to the
motor. After pressing in the switch button, the machine is ready for opera-
tion again.
6. .
RISK OF INJURY DUE TO UNINTENTIONAL
START-UP
When the safety switch is pressed, there is the risk of uninten-
tional start-up
➾
Before pressing the safety switch, make sure that the main
switch [9-1] is in the off (0) position

6.6 Switching on the machine

RISK OF INJURY DUE TO DAMAGED OR
INCORRECTLY MOUNTED MACHINE PARTS
Using the machine with damaged electric parts or power cables
can cause injuries due to electric shocks or malfunctions. Dam-
aged machine parts can be flung away.
➾
Before each use, check the machine for the proper installa-
tion and functioning and for damage.
➾
Above all, check the following parts for functioning and
damage:
– the grinding wheels and honing wheels,
– the polishing wheel (only SM-111),
– the power cable,
– the main switch.
➾
Replace damaged parts before using the machine again.
WARNING
WARNING
Operating instructions, SM-110/-111
6
25