Adjusting The Grinding Arm Angle - Dick SM-100 Operating Instructions Manual

Putting into operation
7
1 Undo the fastening screws [2] of the right-hand side
2 push the right-hand side wall [1] to the rear and remove,
3 turn the grinding belt by hand, at the same time checking
4 if necessary, use the adjusting screw [3] so that the belt runs
5 Screw the side panel back on tight.
6 If necessary, readjust while the motor is running.

Adjusting the grinding arm angle

The angle of the grinding arm can be adjusted before working with
the belt grinder. Adjust the angle as follows:
Figure 7.5 – Grinding arm angle
[1] Adjusting screw
1 Undo the adjusting screw [1],
2 Move the grinding arm into the required position,
3 Tighten the adjusting screw [1].
SM-100 belt grinder
20
panel [1],
whether it drifts to the side,
in the middle of the deflection pulley.
1