Check And Replace Drive Belt; Dismantling The Housing - Dick SM-110 Operating Instructions Manual

8
Servicing and maintenance
4. Install the polishing wheel in reverse order.
5. Insert the mains plug.
6. Switch on the machine and test run it for one minute. In case of unusual
behaviour, switch off the machine immediately and check all individual
parts for proper condition and assembly.

8.8 Check and replace drive belt

If the respective wheel(s) stop during the honing or polishing process, check
the belt and replace if necessary.

8.8.1 Dismantling the housing

1. Pull the mains plug
2. SM-110: Continue with step 5
5
4 4
Image 24 – Dismantling the housing
Only for SM-111:
3. Remove polishing wheel (see 8.7 Replacing the polishing wheel (only for
SM-111)).
44 Operating instructions, SM-110/-111
RISK OF INJURY FROM ROTATING MACHINE PARTS
If the machine is accidentally switched on during maintenance
work, there is a risk of injury due to rotating machine parts.
➾
Always pull the mains plug before carrying out any mainte-
nance work.
1
2
CAUTION
Only for SM-111
[24-1] Countersunk screws
[24-2] Flange incl. fitting screw
[24-3] Star handle
4 4
SM-110 and SM-111
[24-4] Screws on the end faces of
the housing
[24-5] Housing
3