Checking The Belt Condition; Replacing The Flat Belt - Dick SM-110 Operating Instructions Manual

Servicing and maintenance
4. In addition, unscrew the three countersunk screws [24-1] with the
enclosed Phillips screwdriver and remove the flange [24-2] incl. the fitting
screw. Pull off the star handle [24-3]
SM-110 and SM-111:
5. Unscrew the four screws [24-4] on the end faces of the housing with the
enclosed Phillips screwdriver and lift the housing [24-5] upwards.

8.8.2 Checking the belt condition

The belts must not be porous or greasy.
THE DRIVE BELTS MUST ALWAYS BE FULLY
TENSIONED.
If the machine has been exposed to temperatures below +5 °C
for a longer period of time, the tension of the belts is tempo-
rarily reduced. After about one minute of running without load,
the full performance of the belts is restored.

8.8.3 Replacing the flat belt

Image 25 – Replacing the flat belt
1. First remove the belt [25-1] from the large, upper flat belt pulley [25-2].
2. First place the new belt over the small, lower belt pulley [25-1] and then
pull it over the large, upper one.
➾
The textile side of the flat belt must face outwards.
.
NOTE
[25-1] Flat belt
[25-2] large flat belt pulley
[25-3] small flat belt pulley
2
1
3
Operating instructions, SM-110/-111
8
45