Replacing Water Stripping Brush - Dick SM-110 Operating Instructions Manual

Servicing and maintenance
2. SM-110: Continue with step 7.
Only for SM-111:
3. In addition, attach the star handle [27-3].
4. Install the flange [27-2] incl. fitting screw.
5. Screw in the three countersunk screws [27-1] with the enclosed Phillips
.
screwdriver
6. Installing the polishing wheel (see 8.7 Replacing the polishing wheel (only
for SM-111)).
SM-110 and SM-111:
7. Insert the mains plug.
8. Switch on the machine and test run it for one minute. In case of unusual
behaviour, switch off the machine immediately and check all individual
parts for proper condition and assembly.

8.9 Replacing water stripping brush

If the grinding wheels splash water, check the position and condition of the
brushes [28-1] on the knife guides [28-5]. Worn water stripping brushes
must be replaced. Always replace the left and right brush units at the same
time, as both wear out equally.
RISK OF INJURY FROM ROTATING MACHINE PARTS
If the machine is accidentally switched on during maintenance
work, there is a risk of injury due to rotating machine parts.
➾
Always pull the mains plug before carrying out any mainte-
nance work.
CAUTION
Operating instructions, SM-110/-111
8
47