Paradyne COMSPHERE 6800 Series Command Reference Manual page 169

Network management system, communications products support
Table of Contents

Advertisement

COMSPHERE 6800 Series Network Management System
A pop-up menu is available listing valid selections.
Depending on the entry in this field, subsequent fields will be displayed to request additional
information.
The input form that appears when an apl, ddd-local, or 3900 local download is specified contains
the following field:
Device(s) (Required field)
No additional input fields (other than those for specifying results destination and scheduling
information) are displayed.
The input form that appears when a ddd-remote or 3900 remote download is specified contains
the following fields:
Remote device (Required field)
Remote dial number
2-146
3900 mp single
Specifies that a download be performed to a single, remote
3900 Series modem with multipoint configuration.
3900 mp link
Specifies that a download be performed to one or more remote
3900 Series modems with multipoint configuration.
For apl download, enter the 3400/4400 Series modem(s) to which firmware will be
downloaded. For ddd-local download, enter the 3800 Series modem(s) to which firmware
will be downloaded. For 3900 local download, enter the 3900 Series modem(s) to which
firmware will be downloaded. One or more modems may be specified. Standard
addressing format applies to the input. For information on device addressing, refer to
Appendix D of the COMSPHERE 6800 Series Network Management System
User's/System Administrator's Guide.
Enter the 3800/3900 Series remote modem to which firmware will be downloaded. Only
one modem may be specified. Standard addressing format applies to the input.
A remote 3800/3900 Series modem in Dial mode does not have a
fixed link level address. Therefore, if downloading to a
3800/3900 Series modem in Dial mode, the modem's mnemonic
name or serial number must be used.
Enter the telephone number to be used to connect to the specified remote modem. After a
modem is specified in the Remote device field, the Remote dial number field is
automatically populated with the telephone number retrieved from the remote modem's
device profile. You can change this number, if desired. See the modem documentation for
legal dial characters.
January 1997
NOTE
6800-A2-GB31-20

Advertisement

Table of Contents
loading

Table of Contents