Dial Mode (Dm) - Paradyne COMSPHERE 6800 Series Command Reference Manual

COMSPHERE 6800 Series Network Management System

Dial Mode (dm)

(Disruptive)
Use the dm command to switch the primary data path from the private (APL or DDS) facility to
the switched backup facility for COMSPHERE 3400/4400 Series modems and COMSPHERE
3600 Series DSUs. The backup facility must be in place prior to the switch of the primary data
path. The backup facility is established using the Standby Facility (sf) command or the Dial (dial)
command.
For most commands, NMS enables you to specify the destination for the command's results and
schedule its execution. If the last page of the input form cannot accommodate the Destination for
results and Schedule execution fields, an additional page is provided. For a complete description
of these fields, refer to Chapter 1, Introduction.
Access Level:
Abbreviation:
Restrictions:
Routine:
Schedule:
Related Commands: Dial Standby (ds)
Dial Mode Input Form
This input form contains the following field:
Device(s) (Required field)
Dial Mode Results Form
The results form lists device information for each device specified by the user and indicates for
each device whether or not the command was successfully executed.
2-108
Data Technician, Manager, System Administrator
dm
The NMS sends the Dial Standby (dm) command only to the selected
device. Whether both devices on dial connection transfer from dial standby
to dial lines depends, in part, on how they are strapped. Please refer to the
individual device user guides for detailed information on dial connection
transition.
Yes
Yes
Standby Facility (sf)
Dial (dial)
Enter the device(s) whose primary data paths are to be switched. One or more devices
may be specified. Standard addressing format applies to the input. For information on
device addressing, refer to Appendix D of the COMSPHERE 6800 Series Network
Management System User's/System Administrator's Guide.
January 1997 6800-A2-GB31-20