Display Canned Message (Dscm) - Paradyne COMSPHERE 6800 Series Command Reference Manual

Display Canned Message (dscm)

Use the dscm command to display the six stored messages in a COMSPHERE 3400/4400 Series
APL modem. The canned messages are up to 40 characters long and can be sent to an upstream or
downstream device, or to the NMS from the front panel of a 3400/4400 Series APL modem.
For most commands, NMS enables you to specify the destination for the command's results and
schedule its execution. If the last page of the input form cannot accommodate the Destination for
results and Schedule execution fields, an additional page is provided. For a complete description
of these fields, refer to Chapter 1, Introduction.
Access Level:
Abbreviation:
Restrictions:
Routine:
Schedule:
Related Commands: Change Canned Message (chcm)
Display Canned Message Input Form
This input form contains the following fields:
Device(s) (Required field)
Message number (Required field)
Display Canned Message Results Form
The results form lists device information for each device specified, and displays the selected
canned message associated with each device.
6800-A2-GB31-20
You can only transmit canned messages from the front panel of a
COMSPHERE modem. Use the Send Message ( snm ) command to
send a user-defined variable message from the NMS to a
COMSPHERE modem.
Help Desk, Data Technician, Manager, System Administrator
dscm
None
Yes
Yes
Send Message (snm)
Enter the device(s) whose canned messages are to be displayed. One or more devices may
be specified. Standard addressing format applies to the input. For information on device
addressing, refer to Appendix D of the COMSPHERE 6800 Series Network Management
System User's/System Administrator's Guide.
Enter the number of the message to be displayed. Valid entries are from 1 through 6. A
pop-up menu is available listing valid selections.
January 1997
NOTE
2Modem/DSU Commands
2-125