Figure 5-5: Feed The Transducer Cable From The Transducer Side Of The Housing To The Release Side; Figure 5-6: Gently Guide The Transducer End Cap Into The Housing Without The Aluminum Band - Edgetech PORT-LF User Hardware Manual

5-30
1. Feed the transducer cable through the end of the housing without the aluminum band, as shown
in F 5-5, ensuring it comes out on the opposite end.
IGURE

Figure 5-5: Feed the Transducer Cable from the Transducer Side of the Housing to the Release Side

2. Gently but firmly slide the transducer end cap into the housing while aligning the end cap's
orientation key with the housing's matching insert
housing or O-ring sealing surfaces.
housing insert that are properly mated.

Figure 5-6: Gently Guide the Transducer End Cap into the Housing without the Aluminum Band

PORT-LF
(F 5-6). Do not damage the inside of the
IGURE
F 5-7 depicts a transducer end cap orientation key and
IGURE
End Cap Orientation
Key Lined Up With
The Housing Insert
0008595_REV_F