4-18
4.1.4 Closing the Release
Closing the release end includes carefully sliding the electronics board back into the release and replacing
the Kynar rod.
To Close the Release End:
CAUTION:
not to pinch the wiring between the cap and the housing. The
transducer cable should come through the center of the electronic
chassis support bracket.
Transducer Cable
Figure 4-9: Transducer Cable is Run Through the Electronic Chassis Support Bracket
CAUTION:
closed. Be sure not to scratch the housing threading with it.
PORT-LF
Great care must be taken when closing the release end so as
Ensure the grounding spring is inside the release when
Electronic Chassis
Support Bracket
0008595_REV_F