Table of Contents
Advertisement
EN
8.1 FILLING THE TANK
(Fig. 10)
WARNING:
Only add clean mains water to
the tank at a temperature no
greater than 50°C.
-
Remove the hose (1) supplied, connect
one end (1a) to a tap and insert the other
end (1b) in the tank (2).
-
Turn on the tap and fill the tank (2).
-
Pour the liquid detergent into the tank.
N.B.:
Use non-foamy detergents only. For the
quantities, follow the instructions provided by
the detergent manufacturer according to the
type of dirt.
DANGER:
If the detergent comes in con-
tact with the eyes and/or skin
or if swallowed, refer to the use
and safety information booklet
provided by the manufacturer
of the detergent;
-
Once tank filling is complete, it is possible
to:
Insert the hose (1) into the tank (2) fully
where the end (1a) acts as a cap; or re-
move the hose (1) fully and insert the fil-
ter (3) supplied into the tank (2) opening.
EN-18
1a
1b
2
1a
1
2
3
2
Fig. 10
Advertisement
Table of Contents
