HAKO Scrubmaster B12 Manual

Hide thumbs Also See for Scrubmaster B12:

Hako Scrubmaster B12

1. Disconnect mains plug of the charger from outlet and fasten to holder 1.

2. Fill the clear water tank

3. Switch the machine on by the switch

4. Adjust the height of the handle with lever

5. Use pedal

6. Start the suction motor

7. Pull the starting lever to handle

8. Move on. Use switch

necessary )

Qualified persons only are authorised to operate the machine!

The machine is not designed for coarse material! Floor area sweeping before!

Use only cleaning agents suitable for automatic machines ( low-foaming )!

Please pay attention to the informations in the instruction manua!

OPERATION:

from opening 3.

to lower squeegee 6.

and water

under the machine to adjust the water ( if

NOTE! Make sure that pad / brush is installed!!!

( tank volume 16 l )

10.

Brushmotor starts.

Table of Contents

Do you have a question about the Scrubmaster B12 and is the answer not in the manual?

Page 1 Hako Scrubmaster B12 OPERATION: 1. Disconnect mains plug of the charger from outlet and fasten to holder 1. 2. Fill the clear water tank from opening 3. ( tank volume 16 l ) 3. Switch the machine on by the switch 4.
Page 2 Hako Scrubmaster B12 MAINTENANCE AND CARE : Weekly maintenance: Daily maintenance:  Check and clean brush head  Empty the clear water tank from the  Check and clean clear water filter valve 2.  Clean the machine from outside ...