Solution Tank; Filling The Solution Tank - HAKO Scrubmaster B175 R Operating Manual

Maintenance and Servicing
5.4

Solution tank

The filling level in the solution tank is measured continuously and shown in the
MFD in steps of 20 %. If there are less than 10 litres in the tank, a warning
symbol appears in the Fig. 28-A MFD. At the same time, an acoustic warning
is heard and indicates that a top-up is required.
Fig. 28:
5.4.1

Filling the solution tank

Fill the solution tank Fig. 28-25 though the filling opening before commencing
work or as required Fig. 28-B.
Attention
In order to avoid contamination of the drinking water by backflow,
the requirements of DIN EN1717 must be adhered to for filling the
solution tank.
Note
If the machine is equipped with an on-board dosing system, no deter-
gent must be added to the fresh water!
Filling the solution tank with a hose
A
Fig. 29:
1. Place the machine on a level surface.
2. Remove insert in grey cover Fig. 29-A.
3. Fill the solution tank up to approx. 15 cm below the maximum filling level
(maximum water temperature 50 °C).
4. Add detergent according to the manufacturer's regulations via the sieve
insert Fig. 29-B.
78
A
25
B
B
05-7180-00.fm