HIKVISION DS-KD8003 Series User Manual page 90

DS-KD8003 Series Module Door Station User Manual
Steps
1. Click Network → Basic Settings → TCP/IP to enter the settings page.
2. Configure the network parameters.
- Check DHCP, the device will get the parameters automatically.
- Set the IPv4 Address, IPv4 Subnet Mask and IPv4 Default Gateway manually.
3. Select Network Card.
4. Configure the DNS server.
5. Click Save to enable the settings.
Port Settings
Steps
1. Click Network → Basic Settings → Port to enter the settings page.
2. Set the ports of the device.
HTTP Port
The default port number is 80, and it can be changed to any port No. which is not occupied.
RTSP Port
The default port number is 554.
HTTPS Port
The default port number is 443, and it can be changed to any port No. which is not occupied.
Server Port
The default server port number is 8000, and it can be changed to any port No. ranges from
2000 to 65535.
3. Click Save to enable the settings.
Figure 6-5 Port Settings
82