Table of Contents
Advertisement
Effect Memory — with the switcher and AG-RM800
The effect memory can be entered in each event.
[epse Geeta] fee) (areens] 5
AG-A&00
C6) Operate the fader to enter the effect memory. It will be
automaticatly entered.
(1) Enter all the edit points (and set the sync-roil).
Refer to the entering procedure on page 21, 32, 51.
(7) The memory lamp will flash while the fader is in operation.
When operation stops the lamp will go off. The operation
is entered.
The special effect mode can be set on the AG-A800 side.
Set the fader with which the effect memory can be entered
to bus A and turn off the lamp on bus B.
© Select the signal to enter the effect memory.
© Fehearse the edit by pressing the Preview key.
Notes
;
®*The following are the faders to enter the effect memory.
VIDEO:
H/V fader (the V fader cannot be used.)
DSK:
Down stream keyer fader
AUDIO:
= CH1 fader (CH2 is controlled in conjunction with the CH1 fader)
eThe effect memory allows the memorizations of the operations of the Video, Key and Audio effects once for each of the events.
Note that only the effect at the start point (A OUT) and the transition time can be entered if the fader is slid serveral times.
®To memorize the video or audio effect, memorize the sync-roll editing using the editing controller.
if you already have been entered the A/B roil editing, the data cannot be rewritten using this function.
eWhen the down stream keyer effect memory is entered, the start point, the transition time and the end point can be set. When the
fader is moved from IN to OUT and vice versa in step @, the points will be entered as the points between the down stream keyer
effect. The transition times of the fade-in and fade-out effects are the same.
®The A/B roll editing cannot use this function.
id
~53-
xe
«
*
Automatic Search (GO TO)
If you want to check a point quickly, press the GO TO key to cue up to that point.
To Search for a Desired Point
To cue up to that point with the 10 key Numeric Pad, follow the steps below:
—
—
=
88 95 99 82 |
e Select the VTR.
@ Press the GOTO key
while
holding
down
the ENTER key tostart
the VTR.
L=4+e
@ Enter the number of
the desired point with
the 10 key Nu meric Pad,
To Search Edit Points
The cue up to the edit points already entered, follow the steps below:
@ Press the AUDIO
SPLIT key to cue up
to the desired audio
edit point.
The corresponding
lamp will light u up.
eo Select the VTR.
@ Press the GOTO key white hoiding down the IN,
&
A OUT, BIN or the OUT key.
Only operation to the previously entered edit
point is possible on the currentty selected VTR.
-54-
Advertisement
Table of Contents
