Panasonic AG-A800 Operating Instructions Manual page 15

2. VTR or External signal selection
The VTRs selected are controlied by this controller.
"3 [sees ssee
aoe] — |
VTR Selector key "on the
RECORDER SIDE.
VTR Selector keys on the
PLAYER SIDE.
When the AUX key is pressed,
the signal sent from the ex-
ternal unit will be recorded.
3. Entering the Edit Points
There are three ways of entering the points and these are as follows:
4. Enter the points with the Mark IN and Mark OUT keys after locating them with the search dial.
2. Enter the points with the numeric keys.
3. Enter the points with the + and — keys.
3-1. Entering the Edit Points with the Mark IN and Mark OUT Keys
= [209280 62 | 3| [aeeeasce
.. — oD _
ren
ara ia
@ Rotate the search dial to look for the edit point and set the
PLAYER to the still playback at the edit point.
*1f the JOG lamp lights up, press the SHUTTLE dial to set the
unit to the SHUTTLE mode.
SHUTTLE Mode LEX
4") eA
S91
e Set the PLAYER to the JOG mode to look for the edit point
more accurately.
ie. LO
JOG se SHTL
LQ
i
Push
*@SHUTTLE and JOG modes can be selected by pushing
the dial.
©The tape speed varies with the rotation speed of the dial_
The JOG function switches the
tape movement from still to
doubie (2x) the speed when the
JOG dial is rotated. When the diaf
is not rotated, the VTR is always
set in still playback
The tape speed can be increased up to double the speed in
JOG mode. It is convenient to use JOG mode when
getting close to the edit points and to use the SHUTTLE
mode when there is a need to search a great distance of
tape.
Stop the rotation of the Search dial at the edit point. Press
the Mark IN key.
=2 6
The IN lamp will light up and the current position of the
tape on the VTR will be entered as the edit IN point.
EXAMPLE:
When the edit IN point of the PLAYER is entered. the P®
lamp lights up.
e
6) Rotate the Search dial to search for the edit out point.
Stop the rotation of the Search dial at the edit out point.
@ Press the Mark OUT key.
&
(8a) i
Sd
3) The current position of the tape on the VTR willbe entered
as the OUT point and the OUT lamp will light up.
e After entering the edit points from the VTR on the player
side, return to step "2. VTR or External signal selection"
and select the VTR on the recorder side, and then enter the
points on this VTR following the procedure indicated in
step "3. Ente ring the Edit Point".
elf the entered edit points are to be altered or changed,
replace therm with new edit points.
Notes
*lf3 edit points (5 in the A/B roll mode) are entered, the last will
be entered automatically by calculation. The lamp will not
light up.
eThe edit points cannot be entered if there is a mismatch
between the IN and OUT points.