Table of Contents
Advertisement
PLAYER Display
RECORDER Display
e
Enter the OUT point (Hr: Min: Sec: Frame) using the 10
key Numeric Pad.
e Enter the value of the TC or CTL signal of the desired edit
IN point (Hr: Min: Sec: Frame) using the 10 key Numeric
e
Press the Enter key to enter the edit points.
Pad.
The OUT point will be entered and the OUT lamp will light
Enter the edit points on
this VTR
by following the
Procedure in step "3. Entering the Edit Point".
elf the entered edit points are to be altered or changed,
repiace them with the edit points.
C3] Press the ENTER key to enter the edit IN point.
C3) Press the OUT key.
Notes
To enter the edit points on the A roll side during the A/B roll
editing mode, press the A OUT key instead of the OUT key in
step @.
To enter the edit points on the B roll side, press the B IN key
instead of the IN key in step 1. The other procedures are the
same as those from step @ to @.
~23-
3-3. Entering the Edit Points Using the +/— Keys
[comcoe
imal aa
a af aaa
When
using the + key. Entering the edit IN point and
specifying the duration of the editing.
@ Enter the edit IN point using the Mark IN key or numeric
keys. Refer to page 21.
The IN point lamp will light up.
© Press the IN key.
C4) Enter the duration of the editing (Hr: Min: Sec: Frame)
using the 10 key Numeric Pad.
C5) Press the OUT key while holding down the ENT ER key (or
Rress the ENTER key after press the OUT key).
et
°For Audio Split Editing
Refer to page 37.
¢Whaen using the ~ key. Entering the edit OUT point and
specifying the duration of the editing.
@
Enter the edit OUT point using the Mark OUT key or
numeric keys. Refer to page 21.
The OUT point lamp will light up.
@ Press the OUT key.
C4] Enter the duration of the editing (Hr: Min: Sec: Frame)
using the 10 key Numeric Pad.
© Press the IN key while holding down the ENTER key.
an
a
~24-
Advertisement
Table of Contents
