Table of Contents
Advertisement
@ Press the Edit key while holding down the Auto key.
|
*Automatic continuity editing cannot be performed if ail
the necessary edit points are not entered correctly.
© The Auto and Edit lamps will light up and the automatic
continuity editing wilt start.
HH
lf the edit data fist is changed after entering the data, be
sure to modify the edit data tist (Refer to page 64).
Specifying the Range of the Edit
@ Alter the edit, the event numbers will be increased.
©
The Auto and Edit lamps will go off after the last edit.
To stop the execution of an automatic c ontinulty editing
progress.
*To stop the automatic continuity editing after editing the
event whose number is displayed, press the Edit Stop key
once.
©To stop it immediately, press the Edit Stop key twice.
Automatic continuity editing of events can be performed with multiple cuts within a specified range. For example, if the edit data for
the execution of 20 cuts within event numbers 10 to 200 have been entered, you will be able to edit within event n umbers 100 to 150
automatically and continuously.
Follow the procedure below after step @.
(1) Press the Event key.
(2)
Input the desired event number with the numeric keys
from which the editing will start.
(If you not input this event number, it will be automaticaly
entered as the minimum event number.)
(3)
Press the automatic continuity Edit key (~).
Start of
Editing
*The post roll time can be set with the DIP switches.
35
<Operation of the RECORDER during continuous automatic editing>
(4)
Input the number of the fast event to be edited on the
numeric keyboard.
(If this last event number
is not emtered, it will be
automatically entered as the maximum
event number.}
{5)
Press the Enter key.
(6)
Press the Edit key while holding down the Auto key.
The automatic continuity editing will be performed within
the range specified
*Refer to page 60 and 62 to check or cancel the range of
automatic continuity editing.
elf the data has been deleted for the editing of afl the events,
the range will also be deleted.
Overlap
Point
End of
Editing
Editing
Next Editing
Editing Signals from an External Unit (AUX) — with the switcher
(el TT)
eo
@ Press the AUX key.
@ Enter the OUT point using the Search Dial.
HS El
ce
{Hay}
@ Press the Mark OUT key.
OS=2
@
The !N and OUT !amps on the external unit (AUX) and
AUX lamp will light up.
e
Enter the edit points on the recorder VTR side.
Only enter one edit point (IN or OUT) on the recorder VTR
side. The other will be calculated automatically.
There are three ways to enter the points: with the Mark IN
and OUT,
numerics, or + and — keys. Refer to page 21.
e
The edit pwint lamps will light up as shown in the figure
below afte the edit points have been entered.
©
Press the Edit key to edit the signat from the external
equipment .
Notes
®The numeric keys can also be used to set the points on the
auxiliary equipment.
®The IN paint Of the tape on the auxiliary equipment (external
side} is alwayss "00:00:00:00".
*Only enter the IN point on the auxiliary equipment after you
have entered Bhe IN and OUT edit points on the recorder VTR
side.
®For the AUX |.amp, refer to page 53.
— 36-
Advertisement
Table of Contents
