Panasonic AG-A800 Operating Instructions Manual page 29

a I Ey a ST TT 8S Ta RN FORRES A CNM AD :cinc ng
2) Entering the Down Stream Keyer Edit Points
@ Enter ail the edit points. © Press the TRAN key.
Refer to page 20, 30 for the procedure of entering edit .
point.
© Press the KEY key.
The lamp will light up after this key is pressed.
e Set the transition time using the numeric keys.
©The transition times for the fade-in and fade-out effects
rt are the same.
C:) Enter the down stream keyer IN point where the effect will
start and the OUT point where it will end.
e Press the Enter key.
The transition time will be displayed.
Steps © to @ are unnecessary if the down stream keyer
Note
The following keys function as explained below are available
while the KEY lamps are lit.
| FUNCTION
(2) Enter the down stream keyer IN and OUT points. Enter
IN and OUT points.
Dispiays the DSK IN point on the display
of the player VTR side.
The down stream keyer IN and OUT points cannot be
entered as the edit points on the player VTR side. if you wish
to enter these points while monitoring the video picture on
the player VTR side, connect the AG-RM800 and set the
effect memory function or use the MARK IN/OUT keys after
the KEY key is pressed (KEY lamp light up) during the
preview.
*Enter the down stream keyer IN and OUT points on the
editing segment.
Displays the DSK OUT point on the
display of the player VTR side.
OUT
GOTO+IN Cues up to the DSK IN point.
GOTO+OUT | Cues up to the DSK OUT point.
an
MARK IN Enters the DSK IN point.
MARK OUT Enters the DSK OUT point.
vo
- 49 -
eT TENS
3) Set the trarssition time with the numeric keys.
Set the transition time in frame units (0-999).
0 Enter all the edit points.
Refer to the edit point entry procedure on page 20, 30.
@ Press the AUDIO key.
The AUDIO and A/B lamps wilt light up.
ts) Press the Emter key.
The transition time will be displayed.
(——— SwitcHen CONTROL
TRANSOM, ar Tem
Notes
®*Noises may occur if the transition time is shorter than 3 frarnes.
©To enter the video effect, press the Audio key again. The lamp will go off.
©The special audio effect cannot be produced between the P IN and P OUT points. The effect will be produced as entered for the
video effect. During audio split editing, the audio signals will be recorded as showm below.
The transtvon ime 1s produced on this segment
as entered for the video effect
Fade in Fade out
'
t !
' The elfect 1s produced on ttus segment as
i entered for the vdieo effect.
AUDIO IN VIDEO IN VIDEO OUT AUDIO OUT VIDEO IN AUDIO IN AUDIO OUT VIDEO OUT
POINT POINT POINT POINT POINT W®OINT POINT POINT