Panasonic AG-A800 Operating Instructions Manual page 20

(3) Press the A key.
@ Enter the edit points on the recorder VTR side.
It is only necessary enter one of the points, IN or OUT, as
the other will be automatically calculated.
®There are three ways to enter the points. These are using
the Mark IN and OUT, numerics, or + and — keys. Refer
to page 21.
After the points have been entered, the edit point lamps
will light up as shown in the figure below.
For the Audio Split Editing
Refer to page 37.
*For the Special Effect Editing
Refer to pages 40 to 49.
<A/B Roll Editing Operation>
Preroti IN
Point Point
r 1
!
[eo]
AROLL
®To stop the editing operation in progress, press the EDIT STOP key.
*To stop the autornatic continuity editing operation in progress, press the EDIT STOP key twice.
lf the OUT point has not been entered, it will be entered on the section of the tape when you press the EDIT STOP key.
Press the STOP key if not desired.
: Playback picture
Prerolt BIN
Point Point
12) Starting the editing.
When making an edit with a cut.
Set the event on which will start the edit.
evENT
Press the Edit key.
The edit lamp will tight up and edit will start.
When the automatic continuity editing is executed.
Press the EDIT key while holding down the AUTO key.
The AUTO and EDIT tamps will light up and the edit with
plural cuts will be made. Refer to page 34.
1
'
1
'
|
|
' B ROLL
'
Prerolt Editing Start
Point Point
(
t [cor |
RECORDER
t
{
|
i
(
|
t
~31-
Assemble Editing
Edit
dezzzzzi 2202772
Stitt
t
OUT Overlap
Point Point
' '
' ' t
{| Playback picture |
Editing Stop Overtap
Point Point
| EDIT |
Insert Editing
layback
Pl
Still
Manual TAKE Editing (SYNC ROLL) — with the Switcher
This mode is used to operate the switcher manually after starting two VTRs sim ultaneously and making an edit on the recorder VTR
side. Reter to page 12 for information on the connections.
ae 20 08 28 | pert
@ Press the A/B ROLL key.
The A/B roll editing mode will be set after the lamp lights
up. :
©To cancel this mode, press the A/B ROLL key again. The
lamp will go off.
Select the editing mode.
Assemble editing elnsert editing
Select the VTR on the player side that will be the A roll side
and press the key.
+7
The VTR on the player side that has first been selected
will be the A roll side and remember that the VTR for the
B roll side cannot be selected unti} the A roll side has
been selected.
Enter the edit IN point on the A roll.
There are two ways of entering this point, i.e., with the
Mark IN and the numeric keys. Refer to page 21.
°e The edit IN point lamp will tight up after the point is
entered on the A roll.
Hf the A roll side is the P1 VTR.
oe Enter the edit IN point on the B roll.
There are two ways of entering the IN point, j.e., with the
Mark IN and the numeric keys. Refer to page 21.
e The edit IN point lamp will light up as shown in the figure
below after the point has been entered on the B roll.
If the B rolt side Is the P2 VTR.
-32—