Table of Contents
Advertisement
Connection for Using the Time Code Signal
if the time code signal has been recorded on the tape, precision edits can be executed because the position of the tape is indicated
accurately.
AUDIO
CH2 SELECT
NORM
AUDIO [a
TIME CODE
CH2
——
AG-7500
The reading of the time code will be
superimposed on the TV monitor screen.
34P interface
Board
voxom seky Out" — ine coo cr ovennoe
-)) @ Pe
ry
TRHNG
= SELECT.
4
'REMpTE
TIME CODE IN
Connection for Synchronization
This unit can reduce errors by connecting VTRs equipped with connector for synchronization, ie. CAPSTAN
OVERRIDE
connector when synchronized editing is executed.
®To execute normal editing, connect the controlter to the RECORDER VTR.
®To execute A/B roll editing, connect the controller to both PLAYER and RECORDER VTR.
®Please refer to page 69 in the setting of the DIP switch 1-4~6 on "DIP Switch Settings".
VIDEO IN
SUPER OUT
TWAE CODE
CAP OVERRIDE
cape
66
6
VIR
SELECT
ae,
| en
Preparations
Preparations of the VTR connected to this unit
After comnecting the unit to the AU-650B:
®Set the CONTROL switch to "REMOTE".
eSet the REMOTE switch to "RIEM 2 (9P)".
After connecting the unit to the AG-7500, AG-75 10 and
AG-6500:
Set the CONTROL switch to "REMOTE".
Set the CONTROLLER selector to "1".
Set the EDIT switch to "ON".
When
executing time code editing, set the AUDIO CH2
selector to "TIME CODE".
When
inputting the external SYNC signal, set the SYNC
switch to "EXT".
®Set the FRAME SERVO switch to "FRAME".
(When executing colour frame editing, set to "COLOUR")
Preparation for connecting the Switcher AG-SW800
Set the CONTROL switch to "REMOTE".
Preparations of this unit
@ Connect the "TO KEYBOARD" Connector (15P, fe male) on
the I/F Unit to the "TO I/F UNIT" Connector (15P, male) on
the contro! panel.
«—{Female)<cp>
<>
@ Turn on the Power Switch. The corresponding indicator will
light up.
Control Panel
@ Check that all the displays are in operation. The current positions of the ta pes on the selected VTRis are shown an the displays
of the players and recorder.
If the displays are not operating, turn the unit off and then on after verifying that the VTRs are properly connected.
my
Advertisement
Table of Contents
