Yamaha PM5D Owner's Manual page 7

4
5
6
7
8
9
J
K
L
M
N
O
P
D HPF (High Pass Filter)
Switches the high pass filter on/off. You can drag the numeric value up or down to edit
the cutoff frequency.
E Ø (Phase)
Inverts the phase of the signal after AD conversion.
F
INSERT
Enables/disables the insert-out that is patched in the PM5D's INSERT PATCH screen
(INPUT PATCH function).
G
DIRECT
Enables/disables the direct output that is patched in the PM5D's DIRECT OUT PATCH
screen (INPUT PATCH function).
H
GATE
Turns the gate on/off. The indica-
tor immediately below the button
shows the gate's on/off setting
and the open/closed status.
I COMP (Compressor)
Switches the compressor on/off. When the compressor is on, the GR meter immediately
below the button shows the amount of gain reduction.
J EQ (Equalizer)
Switches the EQ on/off. The graph immediately below the button shows the approxi-
mate response of the EQ. You can drag within the graph to edit the response of the EQ.
To reset the EQ to flat response, hold down the <Ctrl> key (
keyboard and click the graph.
K
DELAY
Switches the delay on/off. You can also edit the delay time by dragging the numeric
value located immediately below the button up or down
L
Channel number
Indicates the input channel number corresponding to this module. You can double-
click this number to open the Selected Channel window for this channel.
M
MIX SEND
The bar graphs in this area indicate the send levels of
the signals sent from the input channel to VARI-type
MIX buses. You can also adjust the send levels by drag-
ging a bar graph to left or right.
The bar graph display will change according to the
send position (pre/post) and on/off status of the signal
sent from the input channel to the MIX buses.
For FIXED-type MIX buses, the bar graph is fixed at nominal level (0 dB),
NOTE
and only the on/off status is shown.
N PAN
Sets the panning of the signal sent from the input channel to the STEREO bus.
O SELECT
Selects input channel for which you want to perform operations. This is linked with the
INPUT channel strip [SEL] keys on the PM5D panel. However it will no longer be
linked if you turn Channel Select off (➥ p.2) in the System Setup window.
P CH ON (Channel on) button
Switches the input channel on/off. This is linked with the INPUT channel strip CH
[ON] keys on the PM5D panel.
Gate= closed
(red)
7
Gate= open Gate= off
(green)
key) of your computer
Pre/on (green)
Pre/off (green)
Post/on (yellow)
Post/off (yellow)
PM5D Editor Owner's Manual