Yamaha PM5D Owner's Manual page 18

1
2
3
4
5
6
7
8
9
J
K
A EQ (Equalizer)
Switches the EQ on/off (the L/R settings are linked). The graph immediately below the
button shows the approximate response of the EQ. You can drag the graph to edit the
response of the EQ, or hold down the <Ctrl> key (
and click the graph to reset it to a flat response.
B
COMP (Compressor)
Switches the compressor on/off (the L/R settings are linked). When the compressor is
on, the GR meter immediately below the button shows the amount of gain reduction.
C
INSERT
Enables/disables the insert-out that is patched in the PM5D's INSERT PATCH screen
(OUTPUT PATCH function). (The L/R settings are linked.)
D DELAY
Switches the delay on/off. (L/R settings can be made independently.) You can also edit
the delay time by dragging the numeric value located immediately below the button up
or down
E Channel number
This is the channel number (STEREO A or B) of this module. You can double-click this
number to open the Selected Channel window for this channel.
F MTRX (Send level to MATRIX buses)
Here you can view and edit the send levels of the signals sent from the STEREO A/B
channel to each MATRIX bus. The method of operation and the meaning of the display
6
are the same as for (
G BALANCE
Adjusts the left/right balance of the STEREO A/B channel.
H
SELECT
Selects the STEREO A/B channel for which you want to make settings. (You can specify
L and R independently.) This is linked with the STEREO [SEL] key in the STEREO A/B
channel strip of the PM5D panel. However it will no longer be linked if you turn Chan-
nel Select off (➥ p.2) in the System Setup window.
I
ON
This switches the STEREO A/B channel on/off. This is linked with the STEREO [ON]
key in the STEREO A/B channel strip of the PM5D panel.
J Fader
Adjusts the output level of the STEREO A/B channel. This is linked with the STEREO
fader in the STEREO A/B channel strip of the PM5D panel.
The current fader value is shown in the numeric box immediately below the fader. The
level meter at the right of the fader shows the output level of the signal.
The numbers and alphabetical letters at the right of the fader indicate the DCA group
and mute groups to which that channel belongs, and show the Recall Safe and Mute
Safe status of the channel. (For the significance of the numbers and alphabetical letters,
see ➥ p.8).
K CUE
This button cue-monitors the signal of the STEREO A/B channel. This is linked with
the STEREO [CUE] key in the STEREO A/B channel strip of the PM5D panel.
) MTRX in the MIX window (➥ p.14).
18
key) of your computer keyboard
PM5D Editor Owner's Manual