Download  Print this page

Yamaha PM5D Owner's Manual Page 32

Yamaha pm5d audio mixers: owners manual.
Hide thumbs
Also See for PM5D
User manual - 408 pages
Owner's manual - 367 pages
Setup manual - 35 pages

Advertisement

Table of Contents
❏ Pan / Fader
1
2
3
4
5
6
7
8
A
TO ST (To stereo)
This is an on/off switch for the signal sent from the MIX channel to the STEREO bus.
The PRE button located below selects PRE (immediately before the MIX [ON] key) or
POST (immediately after the MIX [ON] key) as the point from which the signal is sent
from the MIX channel to the STEREO bus.
B
TO ST PAN (To stereo pan)
Sets the panning of the signal sent from the MIX channel to the STEREO bus.
C
LCR
Turns LCR mode on/off for each channel. If this is turned on for a channel, you can use
2
the TO ST PAN (
) knob to simultaneously control the level of the signal sent to the
STEREO bus L/R channels and CENTER channel.
D
CSR (Center Side Ratio)
This adjusts the level ratio (0–100%) of the CENTER channel relative to the STEREO
bus L/R channels. To change the value, drag upward or downward inside the numerical
box.
E
BALANCE
This adjusts the left/right output balance of paired channels. This is not shown if pair-
ing is not specified.
F
ON
Switches the MIX channel on/off. This is linked with the MIX [ON] keys in the MIX
section of the PM5D panel.
G
Fader
Adjusts the output level of the MIX channel. This is linked with the MIX encoders on
the PM5D panel (if the [MIX MASTER] key is on). The current value is shown in the
numerical box immediately below.
H
CUE
This button cue-monitors the signal of the MIX channel. This is linked with the MIX
[CUE] keys in the MIX section of the PM5D panel.
32
PM5D Editor Owner's Manual

Advertisement

Table of Contents

   Also See for Yamaha PM5D

   Related Manuals for Yamaha PM5D

This manual is also suitable for:

Pm5d-rhPm5d editor

Comments to this Manuals

Symbols: 0
Latest comments: