❏ Pan / Fader
1
2
3
4
5
6
7
8
9
J
A
DIRECT (except for FX RTN channels)
Turns the direct output on/off.
B
Direct Output Port (except for FX RTN channels)
Choose the port from which this input channel 1–48 or this ST IN channel 1–4 will be
directly output.
NONE
SLOT1-1, SLOT1-2...SLOT4-16
2TR D1L, 2TR D1R...2TR D3R
C
FOLLOW PAN
Use the following two buttons to specify how the signal sent from the input channel to
the MIX bus will be affected by the TO ST PAN knob (
• VARI button
If this button is on, the PAN knob displayed in the CH to MIX area will be linked
with the TO ST PAN knob if VARI-type MIX buses are paired.
• FIXED button
If this button is on, the signal from after the TO ST PAN (
FIXED-type MIX buses.
D
TO ST (To stereo)
This is an on/off switch for the signal sent from the input channel to the STEREO bus.
This is linked with the [TO STEREO] key in the SELECTED CHANNEL section of the
panel.
E
TO ST PAN (To stereo pan)
Adjusts the panning of the signal sent from the input channel to the STEREO bus. This
is linked with the encoder of each channel if PAN is selected as the encoder mode, and
with the [PAN] encoder of the SELECTED CHANNEL section.
F
LCR
Turns LCR mode on/off for each channel. If this is turned on for a channel, you can use
5
the TO ST PAN (
) knob to simultaneously control the level of the signal sent to the
STEREO bus L/R channels and CENTER channel.
G
CSR (Center Side Ratio)
This adjusts the level ratio (0–100%) of the CENTER channel relative to the STEREO
bus L/R channels. To change the value, drag upward or downward inside the numerical
box.
H
ON
Switches the input channel on/off. This is linked with the INPUT channel strip CH
[ON] keys on the PM5D panel.
I
Fader
Adjusts the input level of the input channel. This is linked with the INPUT channel
strip faders on the PM5D panel. The current value is shown in the numerical box
immediately below.
J
CUE
This button cue-monitors the signal of the input channel. This is linked with the
INPUT channel strip [CUE] keys on the PM5D panel.
No assignment
Output channels of an I/O card installed in slots 1–4
L/R channels of 2TR OUT DIGITAL jacks 1–3
27
5
).
5
) knob will be sent to
PM5D Editor Owner's Manual