Yamaha PM5D Owner's Manual page 10

8
9
J
K
L
M
N
O
P
Q
R
S
H GATE
Turns the gate on/off. The indicator immediately below the button shows the gate's on/
off setting and the open/closed status (➥ p.7).
I COMP (Compressor)
Switches the compressor on/off. When the compressor is on, the GR meter immediately
below the button shows the amount of gain reduction.
J
EQ (Equalizer)
Switches the EQ on/off (the L/R settings are linked). The graph immediately below the
button shows the approximate response of the EQ. You can drag the graph to edit the
response of the EQ, or hold down the <Ctrl> key (
and click the graph to reset it to a flat response.
K DELAY
Switches the delay on/off. You can also edit the delay time by dragging the numeric
value located immediately below the button up or down
L Channel number
This is the number of the ST IN channel for this module. You can double-click this
number to open the Selected Channel window for this channel.
M MIX SEND
The send levels of the signals sent from the ST IN channel to the VARI-type MIX buses
are shown as bar graphs (the L/R settings are linked). You can also adjust the send levels
by dragging a bar graph to left or right.
The bar graph display will change according to the send position (pre/post) and on/off
status of the signal sent from the ST IN channel to the MIX buses (➥ p.7).
N PAN
Specifies the panning of the signal sent from the ST IN channel to the STEREO bus.
(You can set L and R separately.)
O SELECT
Selects the ST IN channel for which you want to perform operations. (L and R can be
selected separately.) This is linked with the ST IN channel strip [SEL] keys on the
PM5D panel. However it will no longer be linked if you turn Channel Select off (➥ p.2)
in the System Setup window.
P CH ON (Channel on) button
Switches the ST IN channel on/off (the L/R settings are linked). This is linked with the
ST IN channel strip CH [ON] keys on the PM5D panel.
Q Channel name
This is a text box that displays the channel name. You can also edit the channel name in
this text box.
R
Fader
Adjusts the input level of the ST IN channel. This is linked with the faders of the ST IN
channel strip on the PM5D panel.
The numbers and alphabetical letters at the right of the fader indicate the DCA group
and mute groups to which that channel belongs, and show the Recall Safe and Mute
Safe status of the channel (➥ p.8).
S CUE
This button cue-monitors the signal of the ST IN channel (L/R are linked). This is
linked with the ST IN channel strip [CUE] keys on the PM5D panel.
10
key) of your computer keyboard
PM5D Editor Owner's Manual