Table of Contents
Advertisement
Installing memory
To install a memory module in the Matrox 4Sight XV6 unit:
1. Ensure that the clips at each end of the Long-DIMM slot are spread.
2. Position the module over the Long-DIMM slot, such that the notch along the
module's bottom edge is aligned with the notch of the Long-DIMM slot. If
installing additional memory modules, ensure they are the same model as the ones
already installed.
3. Gently insert the bottom edge of the module into the slot.
4. Carefully close the two clips over the side notches of the module.
Removing memory
To remove a memory module from the Matrox 4Sight XV6 unit:
1. Spread the clips at each end of the Long-DIMM slot.
2. Lift the module out of the slot.
Adjusting the new memory settings
After installing memory in your Matrox 4Sight XV6, you must adjust the unit's
new memory settings using MilConfig (the MIL Configuration utility). Refer to
the MIL User Guide for more information on using this utility.
Installing or removing RAM
37
Advertisement
Table of Contents
