Matrox 4Sight XV6 Installation And Hardware Reference page 35

4. Slip the edge of the new M.2 SSD into the connector from which you removed
the previous mass storage device. The connecting edge will fit neatly into the
socket, leaving the board at a 20 degree angle from the motherboard.
Caution
Be sure to turn off the power to
the unit and all peripherals as
well as unplug the power from
the unit before adding or
removing devices.
5. Press the mass storage device down and attach it to the motherboard with the same
screw you removed in step 3.
6. Once the SSD is seated, reassemble the case.
7. Reconnect the power to your unit.
Note that, the M.2 SSD will draw its power directly through the motherboard.

8. After your Matrox 4Sight XV6 boots, run the UEFI Setup program to verify that
the SSD is identified correctly.
Replacing the M.2 SSD attached to the M.2 socket
connector
Gently push down
mini board
20°
35