Communication Range Stoo Short; Module Is Easy To Damage; Ber(Biterror Rate)Ishigh - Ebyte EO01C-MLO1S User Manual

LE Chengdu Ebyte Electronic Technology Co., Ltd EO01C-MLOLS User Manual
5 Circuit diagram
STMSL
| ~ 20 VCC
J PC3 PER —— FF
25 pCa
PCI oH —
Lid vee
—9 PAD PCO O75 39 CE
— PAI SPI_SCK/PBS [03 I 70 CSN
—=( pA2 SPI_MISO/PB7 (O= = SCK
—= PA3 SPI_MOSI/PB6 © 2 6 J MOS!
=J VSS SP1_NSS/PB4 3 =i MISO
— 04 VDD PB3 5 rae IRQ
—5C PDO PB2 07 [9 GND
—3 PBO PBl C——— ee
[oe ai i 2 EO1C-MLO1S
iN
6. FAQ
6.1 Communication range is too short
The communication distance will be affected when obstacle exists.
Data lose rate will be affected by temperature, humidity and co-channel interference.
The ground will absorb and reflect wireless radio wave, so the performance will be poor when testing near ground.
Sea water has great ability in absorbing wireless radio wave, so performance will be poor when testing near the sea.
The signal will be affected when the antenna is near metal object or put in a metal case.
Power register was set incorrectly, air data rate is set as too high (the higher the air data rate, the shorter the distance).
The power supply low voltage under room temperature is lower than 2.5V, the lower the voltage, the lower the
transmitting power.
Due to antenna quality or poor matching between antenna and module.
6.2 Module is easy to damage
® Please check the power supply source, ensure it is 2.0V~3.6V, voltage higher than 3.6V will damage the module.
® Please check the stability of power source, the voltage cannot fluctuate too much.
® Please make sure antistatic measure are taken when installing and using, high frequency devices have electrostatic
susceptibility.
® Please ensure the humidity 1s within limited range, some parts are sensitive to humidity.
® Please avoid using modules under too high or too low temperature.
6.3 BER(Bit Error Rate) is high
® There are co-channel signal interference nearby, please be away from interference sources or modify frequency and
channel to avoid interference;
® Poor power supply may cause messy code. Make sure that the power supply is reliable.
® The extension line and feeder quality are poor or too long, so the bit error rate is high;
7.Soldering guidance