Table of Contents
Advertisement
After the parameters have been reconfigured, the module needs to be restarted for the configuration parameters to take
effect.
3.1.6 Remote AT Commands
The NORMAL mode of the E103-W02 allows you to use the remote AT command to send AT commands to the
module's 12476 port using the UDP communication protocol.
command to the module 12476 port using the UDP communication protocol. When using the remote AT command, it is
not necessary to use "+++" to switch modes. Remote commands are only allowed in the NORMAL mode of the module
and will not be used when switching to other modes (e.g. MQTT, HTTP).
Advertisement
Table of Contents
