Adjustments By Dealer - Van Raam OPair User Manual

Adjustments by dealer

The correct tension of the chains
Several chains are present on the tricycle. These must have enough room for movement.
Without any real effort, the chain must be able to be moved about half a centimetre up
and down.
In order to keep tension on the chain, the rear wheel axis can be adjusted. Follow the
instructions below:
1. Slightly loosen the nuts on the rear
wheel axis, allowing the rear wheel to
move back and forth.
2. Tighten the screws on the two chain
tensioners, making the rear wheel
move backwards and tightening the
chain. Do this in such a way that the
chain has some room to move, as
previously indicated.
3. At the same time, make sure the wheel
is straight and located in the middle of
the frame. Not to the left or right. See
figure [A].
4. Lightly tighten the nuts of the rear
wheel axis.
5. Make sure the tension on the chain is
adequate and that the wheel is
attached straight to the frame.
6. Now firmly tighten the nuts.
Version 24.01
1.
[A]
2.
2.
43/55