Table of Contents
Advertisement
Setting the steering
In order to realise optimal steering behaviour
and minimal tyre wear, the steering must be set
correctly.
1. Loosen the left and right nuts of the steering
shaft [A].
Please note! This is a nut with a left wire and a
nut with a right wire.
2. Subsequently turn the steering shaft to adjust
the tracking of the wheels. The wheels must
be set parallel.
3. Tighten the nuts of the steering shaft again.
4. Loosen the two nuts of the steering shaft [B].
Please note! This is a nut with a left wire and a
nut with a right wire.
5. Make sure the steering stop is in the middle of
the steering plate [C]. In case of a dividable
frame, the handlebar is automatically fixed in
this position when the wheelchair section is
disconnected.
6. Subsequently move the steering shaft to
ensure that the wheels face straight ahead
when the steering stop is in the middle of the
steering plate.
7. Tighten the nuts of the steering shaft again.
8. Finally point the handlebar straight ahead.
Make sure the wheels also face straight ahead
at that moment.
9. Check whether the tricycle easily drives
straight ahead on the tyres, without resistance
and friction.
Version 24.01
[A]
[B]
[C]
44/55
Advertisement
Table of Contents
