Adjustments To Be Done By Dealer - Van Raam Twinny User Manual

Adjustments to be done by dealer

The correct tension of the chain
There are two chains on the bicycle. The chain should not be too tight. It should hang
loose. Without effort you should be able to move the chain up and down, half a centimetre
approximately.
Chain Twinny en Kivo:
To keep the chain tension correct, the back
wheel axle is adjusted. Follow the instructions
below to adjust the chain tension:
1. Slightly loosen the nuts of the back wheel
axle, so that the back wheel can move
backwards and forwards.
2. Tension the nuts on the two chain-
tensioners, so that the wheel slides
backwards and the chain gains tension. Do
this is such a way that the chain hangs
loosely, like described earlier.
3. Tension the nuts the same amount of turns,
so that the wheel is straight and positioned
in the centre of the frame, as illustrated. Not
to the left or right, see figure [A].
4. Slightly tighten the nuts of the back wheel
axle.
5. Check whether the chain tension is correct
and whether the wheel is straight and in the
centre of the frame.
6. Tighten the nuts thoroughly.
User manual | Tandems 20.01
1.
2.
[A]
2.
38