Van Raam VeloPlus3 User Manual page 31

Exclamation mark (symbol)
Exclamation mark (symbol)
Active assistance mode is
flashing
Active assistance mode is
flashing
All assistance settings are
turned off.
Charging and maintenance of the battery pack
Important safety warning:
Charger safety precautions
Only charge Van Raam Li-Ion batteries with the supplied charger. Only connect the
•
charger to a suitable wall socket (220-240 Volt AC 50-60 Hz). When the charger is not
in use, disconnect it from the power outlet and the power plug from the battery.
The charger may only be used by persons who have read the information in this
•
manual and are familiar with the correct use of the charger. Keep the charger out of
reach of children; they should not play with the charger.
The charger is designed for use in a dust-free, dry and ventilated environment. Do not
•
expose the battery to water, heat sources and direct sunlight. Keep the charger clean
and dry.
Do not charge batteries that feel hot. The battery may only be charged in places where
•
the temperature is no higher than room temperature. Stop charging if the battery gets
hotter than (> 40 ° C).
Caution! The charger can become warm during charging > 50 ° C. First, carefully feel
whether you can pick up the charger, this temperature can cause hypersensitivity or a
startled reaction when it comes into contact with the skin.
Do not use the charger if it is visibly damaged or modified. Do not repair the charger
•
yourself! Please contact Van Raam. You are strictly prohibited from opening the
charger yourself!
Version 24.01
Voltage too low
Controller
communication error
Electrical current too
high
Motor sensor fault
The battery is
almost empty.
System does not provide
assistance, check the connection
between controller and battery.
Check how full the battery is.
System does not provide
assistance. Contact your dealer.
System does not provide
assistance. Contact your dealer.
System does provide assistance.
Contact your dealer.
Charge the battery
31/51