Table of Contents
Advertisement
3.11.3 Electric starter assembly
Replace the O-ring (6) each time it is disassembled.
Fit the O-ring (6) on the electric starter (4).
Insert the electric starter (4) into the crankcase housing (5).
Insert the 2 flange-head screws M6x35 (3) into the electric starter (4) and tighten with the torque
shown in the figure.
Insert the O-ring (6) on the rear of the electric starter (4).
Position the reinforcement plate (2).
Insert the 2 Allen screws M6x20 (1) in the plate (2) and tighten with the torque shown in the figure.
M6x35: 10 Nm
M6x20: 10 Nm
Cosmos 300 – Maintenance manual – V2
84
Advertisement
Table of Contents
