Table of Contents
Advertisement
Measure again the distance between the clutch and the transmission cover separation
plane. Check that it coincides with the measurement taken previously.
Lubricate the roller bearings, the clutch bell and the surface of the crankshaft with transmission
oil.
Insert the bushing (11) and the 2 roller bearings (9) on the crankshaft (10).
Insert the clutch bell (8).
Insert the nut M14x1,5 (6) with the washer (7) and tighten with the torque shown in the figure.
Use a torque wrench, do not use a pneumatic impact screwdriver.
100 Nm
Cosmos 300 – Maintenance manual – V2
142
Advertisement
Table of Contents
