Vittorazi Motors COSMOS 300 Maintenance Manual page 179

Insert the remaining Allen screw M6x30 (6) with washer (7) on the head.
Tighten the 7 Allen screws M6x30 alternately and cross-tighten with the torque shown in the
figure.
Check that all 7 Allen screws M6x30 are tightened correctly.
10 Nm
Grease the O-ring (4) with FP Silicompound 225 and place it on the connector (3).
Insert the thermostat (5), the connector (3), the 2 Allen screws M5x10 (1) with washers (2) and
tighten with the torque shown in the figure.
3 Nm
Cosmos 300 – Maintenance manual – V2 179