Table of Contents
Advertisement
3.5.3 Reed valve assembly
Replace the petals (11) and place them against the bearing surface (12).
Position the stoppers (10).
Insert the 3 Phillips screws M3x6 (9).
Check that the petals rest perfectly on the surface of the reed valve (see previous photo).
Please note: the two chamfers on the stopper and on the petals (blue circles) may not match.
Carry out the same operations on the other side of the reed valve.
Replace the gaskets (3, 7) each time they are disassembled.
Cosmos 300 – Maintenance manual – V2
37
Advertisement
Table of Contents
