Table 3: Switch Status Led Configurations - Mellanox Technologies InfiniScale MIS5022Q-1BRR User Manual

InfiniScale® IV 8-Port QSFP 40 Gb/s InfiniBand Switch User Manual
If the status LED shows red after
nox representative for assistance.
If the fan LED shows red unplug the switch and call your Mellanox representative for
assistance.
If the switch shuts down due to over-temperature, unplug the switch, wait 5 minutes
and replug in the switch. For more information See "Troubleshooting" on page 35.
4.1.1.2 Status LED
The status indicator is located on the left side of the front panel (connector side) of the unit. The
following status conditions are possible:
Table 3 - Switch Status LED Configurations
LED Configuration
Off
Solid Green
Blinking Green
Figure 3: Status LEDs
30 seconds
No power to the switch.
OK – the switch is running.
All OK.
Switch is booting up.
unplug the switch and call your Mella-
LED Description
Mellanox Technologies
Rev 1.4
17