Status Leds; Figure 18: System Status Leds - Front And Rear Sides; Table 12: System Status Led Assignments - Mellanox Technologies TX6000 Hardware User Manual

3.2.2

Status LEDs

3.2.2.1 System Status LED
Both of the System Status LEDs (front and back) supply identical information.
It may take up to five minutes to turn on the system. If the System Status LED shows
red after five minutes, unplug the system and call your Mellanox representative for
assistance.
Table 12 - System Status LED Assignments
LED Behavior
Solid Green
Flashing Green
Solid Red
Off
3.2.2.2 Fan Status LED
All fans must be operating while the power supply is plugged in.
31 Mellanox Technologies

Figure 18: System Status LEDs - Front and Rear sides

Both of these LEDs show the
system's status.
Rear side
status LED
Description
The system is up and running (normal
condition).
The system is booting up. This assignment
is valid on managed systems only.
Major Error has occurred. For example,
corrupted firmware, system is overheated
etc.
The system has no power.
Front side
status LED
Action Required
N/A
Wait up to five minutes for the end of the
booting process.
If the System Status LED shows red five
minutes after starting the system, unplug the
system and call your Mellanox representa-
tive for assistance.
Check the power source and cable.
Interfaces