Internal Zone Paging With Meet-Me Page - NEC UNIVERGE SV9300 User Manual

TO INITIATE
1.
Press Speaker key.
You will receive a dial tone.
Speaker key lamp lights red. →
2.
Press Dial Intercom feature key.
Dial Intercom feature key lamp lights
green. →
ICM
11:00 AM SUN 1 JUN 2014
Recall PICK
3.
Dial desired intercom terminal
number ( -
4.
Press .
Change to ring tone signal.
Tone burst is sent.
TO ANSWER
1.
While hearing ringing tone,
Dial Intercom feature key lamp flashes
green. →
Tone burst or ring tone is heard.
ICM
11:00 AM SUN 1 JUN 2014
MIC DIR
2.
Press Dial Intercom feature key.
Dial Intercom feature key lamp lights
green. →
3.
Press Speaker key.
You will receive a dial tone.
Speaker key lamp lights red. →
200
>>>>
).
201
HIST. >>>>
87
FEATURE OPERATION
INTERNAL ZONE PAGING
WITH MEET-ME PAGE
This feature allows terminal users to page over
the built-in speakers of the terminals within the
assigned zone or all zones.
The feature access code/feature key is
set by system data setting at initial
installation. For details, please contact
the system administrator.
TO PAGE (TERMINAL A)
The terminal A pages the terminal B.
1.
Press Speaker key.
You will receive a dial tone.
Speaker key lamp lights red. →
2.
Dial Internal Paging access code for
desired zone or all zones or press
Internal Paging feature key
assigned for desired zone or all
zones.
PAGING
11:00 AM SUN 1 JUN 2014
Recall PICK
3.
Page the terminal B.
TO ANSWER (TERMINAL B)
1.
Dial Meet-Me Answer access code.
They are immediately connected.
11:00 AM SUN 1 JUN 2014
MIC Mute
>>>>
200