NEC UNIVERGE SV9300 User Manual page 101

If incorrect password is entered three
times consecutively, the terminal locks
up, and any key operation will be
disabled for 10 minutes. And the
number of failed passwords entry and
terminal lock up time are set by system
data setting at initial installation. For
details, please contact the system
administrator.
While the terminal is locked,
becomes disabled. Also, any features
provided by the system, such as call
origination or call answering, cannot be
performed.
Even when the terminal is reset for any
reasons (such as power-off, etc.) while
the terminal is placed in Security Mode,
the lock is not released. For the way for
resetting Security Mode, please contact
the system administrator.
TO LOCK OR UNLOCK
SECURITY MODE
TO LOCK THE TERMINAL
1.
Press Security button on the
terminal.
2.
The following message is displayed
on LCD. Press
3.
The terminal is in Security Mode.
Security lamp lights red.
The Screen Saver will be activated.
TO UNLOCK THE TERMINAL
1.
Press any key while the Screen
Saver is activated.
The password entry screen is displayed
key
or Soft key (OK).
93
FEATURE OPERATION
on the LCD.
2.
Enter the password, and press
or Soft key (OK).
To cancel the Security Mode, the
"terminal password" is required. The
default password to release a security
lock is "0000". Be sure to change the
default password before placing the
terminal in Security Mode.
For details, please refer to
CHANGE PASSWORD.
3.
Security lamp goes off.
Security Mode is canceled.
When the password entry ends in

failure, the following error message
is displayed.
Security Mode is continued by

pressing Soft key (Cancel).
Password retry screen is displayed

again when
is pressed.
After a third attempt (if incorrect

password is entered three times
consecutively), the following error
message is displayed.
Security Mode is continued by

pressing
After 10 minutes later and press

any key, the password entry
screen is displayed.
TO
or Soft key (OK)
or Soft key (OK).