NEC UNIVERGE SV9300 User Manual page 62

When the backup process ends in
failure, "Upload Failed!" is displayed
on the LCD. Check to see the following
points and retry backup.
CHECK POINTS
Check whether IP
address/address (URI)
of FTP/TFTP/HTTPS
server is correct or not.
Check whether the
power to
FTP/TFTP/HTTPS
server and network
equipment are ON or
not.
Check whether the LAN
cable is connected
securely.
If the retry of uploading fails many
times, the terminal may be in failure.
For details, please contact the system
administrator.
Other than above conditions, if
"Download Failed!" or "Upload Failed!"
is displayed, please contact the system
administrator.
TO RESTORE THE SETTING
DATA OF TERMINAL
1.
Press key to display the Menu
Screen.
2.
Select "Setting".
Highlight an item by using
.
ACTIONS
Set the proper IP
address/address
(URI) of
FTP/TFTP/HTTPS
server.
Turn on the power.
Reconnect the cable
securely.
, and press
54
3.
Select " Data Backup/Restore".
Select one of the following operations.
 Highlight an item by using
press , or Soft key (OK).
 Press
.
4.
Select " Protocol".
Select one of the following operations.
 Highlight an item by using
press , or Soft key (OK).
 Press
.
5.
Select a Protocol type of the server
which stores the Backup file.
Select one of the following operations.
 Highlight an item by using
press or Soft key (OK).
 Press
,
or Soft key (OK).
The display goes back to the
[Backup/Restore] screen.
6.
According to the selection in
[Protocol] screen, proceed to the
following steps below.
 When "
FTP" is selected here, go to
7
TERMINAL SETUP
, and
, and
, and
or , and press