NEC UNIVERGE SV9300 User Manual page 133

SWITCH THE MODE OF TERMINAL
When the terminal is connected with smart device though Bluetooth, the terminal mode can be
switched by pressing the Path key. (Wired Telephone Mode/ Mobile Phone Mode)
The status of the terminal mode switched by the Path key lamp is as follows.
MODE
Wired Telephone Mode Orange
Wired Telephone Mode Orange
Mobile Phone Mode
SWITCH THE MODE OF TERMINAL (WIRED TELEPHONE MODE/ MOBILE PHONE MODE)
1.
Press Path key when the smart device is idle or receiving an incoming call.
2.
The mode is changed. (Wired Telephone mode or Mobile Phone mode)
TO SET SMART DEVICE TYPE BY PATH KEY
This section explains how to set the type of smart device to be connected to the terminal by using Path
key. The following smart device types can be set to the terminal.
Type1: iPhone, iPad

Type2: Other Smart Device

1.
Long press Path key, when the terminal is idle.
2.
After the smart device type is set, confirmation beep is heard as follows.
Type1
Once (iPhone, iPad)
Type2
Twice (Other Smart Device)
APPENDIX D PAIRING WITH SMART DEVICE
LAMP COLOR
Green
125
LAMP INDICATION
(Flashing interval is
shown in seconds)
Lighting
Flashing
(0.25 ON-0.25 OFF)
Flashing
(0.125 ON-0.125
OFF-0.125 ON-0.625
OFF)
Flashing
(0.5 ON-0.5 OFF)
Flashing
(0.125 ON-0.125 OFF)
Lighting
Flashing
(0.125 ON-0.125 OFF)
TERMINAL STAUS
Smart device is idle or
not be connected.
Smart device is playing
music.
Smart device is
receiving an incoming
call.
Smart device is
originating a call or
talking.
Talking with smart
device.
Smart device is idle or
ringing by
communication server.
Smart device is talking
with the caller through
communication server.