Table of Contents
Advertisement
Message
Example display:
"---"
displayed where
the ORP value
should be
• The
• The sensor has been automati cally blocked
by the pH overdose safeguard.
"pH dosing
• The pH value measured remains higher
STOP"
than the pH setpoint despite an injecti on
("INFO"
cycle customised by the pH overdose
indicator
safeguard.
fl ashing)
Tip: if you require assistance, inform your retailer about the appliance's conditi on to save ti me
8.2 I Wi-Fi LED behaviour
Control box status
• The
LED is off
• The
LED is fl ashing
• The
LED is on steady
• Pairing can be restarted regardless of the connecti on status by simultaneously pressing
seconds.
Possible cause
- - -
0
value measured is
• Appliance not connected or Wi-Fi network issue (modem malfuncti on,
changed network name or password, etc.)
• Repeat the pairing process. If the LED is sti ll not lit despite the pairing att empt,
disconnect the reconnect the appliance to the mains power supply.
• Pairing in progress. To stop pairing, disconnect the appliance from the power
supply.
• Appliance connected to the Wi-Fi network and accessible via the app.
Soluti on
• Check the connecti on between the sensor
and the control box, re-connect if necessary
and the control box, re-connect if necessary
(contact your retailer)
• While waiti ng for a replacement sensor,
deacti vate the ORP functi on in the service
menu in order to switch to manual operati ng
.
mode (contact your retailer)
• Check or replace the container.
• Check and adjust the alkalinity (TA) of the pool
water.
• Check/clean or replace the pH sensor.
Meaning
.
.
EN
+
for 4
55
Advertisement
Table of Contents
