Table of Contents
Advertisement
Getting Started
4.2 GUI Installation and Working with GUI
The GUI can be found
here
shows the default interface of GUI. Please refer to the README.md file in the GUI tool for a complete guide on
how to use the tool.
The EVM can be configured in the configuration page as shown in
registers are locked and CRC protected. Clicking the Unlock registers check box on the Configuration Page
automatically writes REGISTER_LOCK_STATUS =0x9B to unlock the configuration registers for write operation.
CRC can be disabled by writing CONFIG_CRC_EN = 0h through Console window (Options → Show Console) or
GUI Register Map Page. For example, output voltages, startup and shutdown delays and peak current limits can
be changed for each buck converter.
8
LP87725Q1EVM Evaluation Module
and the GUI can be run in browser or can be installed to the computer.
Figure 4-1. GUI Front Page
Copyright © 2023 Texas Instruments Incorporated
Figure
4-2. By default, all the configuration
SNVU851 – NOVEMBER 2023
www.ti.com
Figure 4-1
Submit Document Feedback
Advertisement
Table of Contents
